Compiling the model

This section describes compiling the model

Once the schematic diagram is completed, it can be compiled by pressing the (Compile schematic) button. The compilation process will display messages in a console (Figure 1). The compilation process can be stopped at any time by pressing the Stop button next to the compilation indicator (Figure 2). When stopping the compilation process, please bear in mind that an interrupted compilation process may result in incomplete target files, which may fail to open in the HIL SCADA or can produce unexpected simulation responses.

In case of an error in the compilation process, please check the schematic diagram.

Figure 1. Compilation status window
Figure 2. Compilation indicators