Kick-start your control development
HIL Launchpad Interface provides a pin-to-pin compatible interface between Typhoon HIL emulators and C2000 series Launchpads. In less than 5 minutes you can plug a HIL Launchpad Interface to a Typhoon HIL real-time emulator, map the signals and run with a closed loop control.
You can now focus on DSP control code development, without worrying about schematic and PCB design. Analog outputs are also available to plug directly into an oscilloscope without any hassle.
Ready solution for your classroom
HIL Launchpad Interface with HIL402 workstation offers engaging, highly interactive and fun approach to learning power electronics and digital controls applied to grid connected converters, motor drives, renewables, active filters and smart grid applications. Students quickly get immersed by first running pre-packaged controller code examples under different operating conditions including grid disturbances and faults.
Subsequently, students progress and learn to develop open loop control, and then closed loop control, including PWM modulation, PLL synchronization with the grid, grid currents control and DC link voltage control. All this in a completely safe environment while working with “MW” of power.
HIL Launchpad Interface technical details
| Supported TI Launchpads | LAUNCHXL-F28027F LAUNCHXL-F28069M LAUNCHXL-F28377S LAUNCHXL-F28379D |
| Programming | via Launchpad’s USB |
| Launchpad Pins | All 80 pins routed. Check pinout at Launchpad documentation |
| Signal Probes | 10x Analog Probes for HIL’s analog outputs and Launchpad’s DAC |
| Power source | from HIL |