HIL DSP 180 Interface

Plug-and-play solution for Texas Instruments controllers.

Kick-start your control development


HIL DSP Interface provides a pin-to-pin compatible interface between Typhoon HIL emulators and C2000 control cards. In less than 5 minutes you can plug a HIL DSP Interface to a Typhoon HIL real-time emulator, map the signals and run with a closed loop control.

You can now focus on DSP control code development, without worrying about schematic and PCB design. All required protocols, such as JTAG and UART, are available and accessible.


Ready solution for your classroom


HIL DSP Interface with HIL402 workstation offers engaging, highly interactive and fun approach to learning power electronics and digital controls applied to grid connected converters, motor drives, renewables, active filters and smart grid applications. Students quickly get immersed by first running pre-packaged controller code examples under different operating conditions including grid disturbances and faults.

Subsequently, students progress and learn to develop open loop control, and then closed loop control, including PWM modulation, PLL synchronization with the grid, grid currents control and DC link voltage control. All this in a completely safe environment while working with “MW” of power.

HIL DSP Interface technical details

For more details take a look at the brochures:HIL DSP180 Interface


HIL DSP180 Interface
Supported TI ControlCards TMDSCNCD28379D


Programming via USB on ControlCard
JTAG connector 13-pin IDC
CAN connector RJ45
Power from HIL or external